Las Vegas & Henderson, NV · Mon–Fri 8 AM–7 PM · Sat–Sun 8 AM–4 PM (702) 707-5107

LG refrigerator error codes

LG refrigerators show error codes as "Er" plus a short code, often split across the freezer and fridge temperature displays (for example Er IF or Er FF). Fan codes (IF, FF, CF, rF) and defrost codes (dH, dS) are the most common, and many fan codes are actually caused by ice from a defrost or seal problem.

Reviewed by LG Appliances Repair Service technicians · Updated

How to read and reset an LG refrigerator code

  • Most LG refrigerators show the code on the temperature display — for example Er on the freezer display and IF on the refrigerator display. Some show only the code, or a series of blinking lights.
  • To reset, unplug the refrigerator (or switch off its breaker) for 5 minutes, then restore power. If the code returns within hours, the fault is still there.
  • Codes for fans and sensors appear only when the main board reads 0 V or 5 V on that circuit — meaning an open or shorted part or wiring, not a "maybe."
  • Seeing OFF or O FF with no cooling? That is demo mode, not a failure — see below.

Fan codes

CodeMeaningWhat to do
Er IFIce compartment (icing) fan error — the board lost the fan's feedback signalMost often ice has built up around the ice-room fan. A full defrost restores it temporarily; the lasting fix is the fan and the seal or duct letting moisture in. Call for repair.
Er FFFreezer (evaporator) fan errorUsually ice around the fan from a defrost failure, sometimes a failed fan motor. Defrosting alone will not last — book a diagnosis.
Er CFCondenser fan errorCheck the fan behind the lower rear cover for debris. If it does not spin freely or does not run, the condenser fan motor needs replacing.
Er rFFresh-food (refrigerator) fan errorThe fresh-food fan has stopped or is blocked by ice. Call for repair.

Defrost and temperature sensor codes

CodeMeaningWhat to do
Er dHDefrost heater error — the defrost sensor did not warm up in time, or the heater circuit is open (may show as rdH / fdH on dual-evaporator models)Expect frost on the back freezer wall and warm fresh food soon. Defrost heater, sensor or fuse repair.
Er dSDefrost sensor errorThe sensor or its wiring is open or shorted. On many LG models the sensor comes with the heater.
Er rSRefrigerator (fresh-food) sensor errorSensor or wiring open or shorted; temperature control becomes inaccurate. Call for repair.
Er rS2Second fresh-food sensor errorSame as rS for the second sensor.
Er FSFreezer sensor errorSensor or wiring open or shorted. Call for repair.
Er rtRoom (ambient) temperature sensor errorSensor near the hinge or top of cabinet open or shorted.
Er HSHumidity sensor errorSensor or wiring fault; cooling continues but control is less precise.
Er SSPantry (special drawer) sensor errorPantry sensor or wiring fault.
Er CSConvertible drawer sensor errorSensor in the convertible drawer open or shorted.

Ice maker and water codes

CodeMeaningWhat to do
Er ISIn-door ice maker icing sensor errorSensor wiring runs through the left hinge; check for a pinched harness. Call for repair.
Er ItIn-door ice maker error — no power, jammed with ice, or failed ice makerRemove the bucket, clear ice and run the ice maker test button. If it does not move, the ice maker needs service.
Er IEFreezer (cubed) ice maker errorThaw a possible jam; if it persists, ice maker or wiring fault.
Er IUFreezer ice maker errorSame as IE on models with an in-freezer ice maker.
Er IdIn-freezer ice maker icing sensor errorSensor or wiring fault.
Er IHFreezer ice maker sensor errorSensor or wiring fault (sensor wiring often under the left hinge cover).
Er ICCraft Ice (mini cube) ice maker motor errorLoose connection or failed Craft Ice motor.
Er IOCraft Ice ice maker temperature sensor errorSensor or wiring fault on the Craft Ice maker.
Er gFWater flow meter error — no water flow detectedCheck that the water supply valve is open and the filter is seated and not clogged. Low household pressure can also trigger it. If water is on, the flow meter or inlet valve has failed.
Er EttWater tank switch errorTank switch or wiring fault.

Communication and board codes

CodeMeaningWhat to do
Er COCommunication error between the main board and the displayUsually wiring through the left door hinge, sometimes a board. Call for repair.
Er CO2Display board and dispenser board not communicatingConnection or board fault.
Er EC1Display / dispenser power board communication errorCheck for 12 V supply to the boards; often a wiring issue in the door.
Er SdDispenser sub-board communication errorLG notes most cases are wiring — disconnected harness, bent pins or broken wires in the door.
Er SCRGB (MyColor InstaView lighting) sub-board communication errorWiring or RGB board under the hinge cover.
Er OdWi-Fi module errorWi-Fi module, connector or display board. Cooling is not affected.
Er UCUV dispenser-sanitizing LED module errorUV module fault; cooling is not affected.
Er PSProximity sensor errorSensor or connection fault on models with a proximity-activated display.
KNOBRotary knob errorLoose connection or failed control knob.

Sealed-system codes (test mode)

CodeMeaningWhat to do
CLSealed system low-side leak errorPossible refrigerant leak (often the evaporator), compressor problem, or a door left open for a long time. Needs an EPA 608 technician — see refrigerant leak repair.
CHSealed system high-side error — leak, restriction, compressor or valve problem; on some models a bad defrost sensorNeeds sealed-system diagnosis — see compressor replacement.

Auto door and drawer codes

CodeMeaningWhat to do
Er EAdAuto door motor did not reach position in 5 secondsCheck for obstructions; hall sensor, motor or module fault.
Er EASAuto door reed switch errorReed switch or connection fault.
Er EdL / Er EdrLeft / right auto drawer motor errorHall sensor, motor or drawer module fault.
Er LAS / Er rASLeft / right auto drawer reed switch errorReed switch or connection fault.

Not error codes

CodeMeaningWhat to do
OFF or O FFDemo (display) mode — all cooling is offOn many models: open a fridge door and press Ice Plus 3 times while holding the Refrigerator button (button names vary by model — check your manual). The display returns to temperatures and cooling starts.
t ocInstaView display (store demo) modeTurn off the demo mode as described in your manual.
SbSabbath modeHold Wi-Fi + Freezer for 3 seconds (or Freezer + Water Filter on models without Wi-Fi).
SF / Sr / SStService compensation modes used by techniciansExit by cycling power.
EbU / EFE / EFU / ErUFactory memory codes — no errors storedIgnore.
UPThinQ feature update availableNot a fault. Update through the LG ThinQ app.

When to call

Any fan, defrost, sensor or communication code that comes back after a 5-minute power reset needs a technician. Fan codes on LG refrigerators are often a symptom of ice, so the repair must also fix the defrost or seal problem that made the ice. We carry LG fans, sensors, defrost heaters and ice makers on our trucks. LG refrigerator repair · $75 service call, credited toward the repair.

LG refrigerator error code questions

How do I clear an error code on my LG refrigerator?

Unplug the refrigerator or switch off the breaker for 5 minutes, then restore power. If the code was caused by a temporary condition it will not return. If it comes back, the part or wiring it points to has a real fault.

Why does my LG refrigerator say Er IF?

The ice compartment fan has stopped sending its feedback signal — usually because ice has frozen around the fan blade in the door ice room, sometimes because the fan motor has failed.

Why does my LG refrigerator display OFF?

Demo mode is on. In demo mode the lights and display work but nothing cools. Turn demo mode off using the button combination in your manual.

What does CL mean on an LG refrigerator?

LG uses CL for a sealed-system low-side leak error. It points to a possible refrigerant leak or compressor issue and needs an EPA 608 certified technician. On some washers and dishwashers CL means child lock — a different thing.

Online booking

Code keeps coming back? Book a technician

Tell us what the appliance is doing and when you are home. We call back to confirm a time — usually the same day during business hours. The $75 service call is credited toward your repair.

  • EPA 608 certified
  • Fully insured
  • $75 service call, credited to repair
  • 90-day labor · 1-yr parts warranty

Request LG repair

Prefer to talk? Call (702) 707-5107. We confirm online requests during business hours.

LG appliances only · Las Vegas & Henderson

Your LG appliance, fixed by technicians who work on LG every day.

$75 service call, credited toward the repair. Written quote before any work. EPA 608 certified, fully insured. 90-day labor warranty, 1-year warranty on parts.

Call now Book online